5 of the most important benefits of a water jet cutting equipment
If you have already manufactured with the water jet cutting systems or is still starting to get a head start for it, you should be able to know all of the benefits that it is going to give you. There are benefits that can be provided by the water jet cutting systems and it would be helpful to you in making a good business decision if you are able to read more about it from this article.
Abrasive waterjet cutting, as well as pure waterjet cutting, are the two kinds of methods that exist in the waterjet technology. The pure waterjet cutting method is a process that used only water stream for cutting soft materials such as paper or foam, and other soft goods as well. This is in contrast with the abrasive waterjet cutting method wherein a granular abrasive needs to be added in the water stream. It is the job a the granular abrasive to accelerate the power that the cutting stream holds so that hard materials will easily be cut such as ceramics or metal.
Know more about the waterjet technology with these five benefits that are being outlined for you:
1. The waterjet technology is applicable to almost every material so there is no limitation
Almost all kinds of materials are being cut by the waterjet technology including rubber, rock or stone, ceramics, plastics, composites, and metals. In order for you to be able to acquire quality cut material of up to 200 mm in thickness, it would be best for you to make use of the granular abrasive to be added to your water et cutting systems.
2. You do not have to worry about the HAZ or the heat affected zone
The HAZ or the heat affected zone should be less of your worries since the water jet cutting equipment is made up of a cold cutting method. Clean cuts are being given off by cold cutting as well as the increase in the safety of the operator by making sure all risks of burns are eliminated.
3. There is no distortion of materials
The heat exposure of the materials can be bypassed because of the cold cutting method and this is very much needed especially in handling hard materials such as metal where distortion is possible to happen. A burr-free cut and a smooth cut is the after effect of this method.
4. This particular method will not make you do some finishing process to your product.
The products will be provided with the highest cutting quality with accurate results that is why you do not need to worry about any finishing process that you might need to apply.
5. No need to worry about any hazardous waste
It is a must for business establishments these days to make sure that their products are environmentally friendly since this process is becoming more apparent in the industry.